SPOT WELD DRILL BITS AT HARE & FORBES

115 Views

If you need to separate and remove spot-welded panels or components, this inexpensive tool will make the job much easier without damaging the underlying panel.

The SW10 spot weld drill bit cutter is easy to use with just a few simple steps. Firstly, centre punch all your spot welds you need to drill, centre drill all welds on the panel or piece to be removed, then attach your spot weld drill bit cutter to a variable speed hand-held drill for better control. Align the centre point of your tool on the pre-drilled centre hole, push down, and drill carefully until you cut through the first layer only on all the welds. Then, just manipulate the panel away when all welds have been drilled. It really is as simple as that!

The SW10 spot weld drill bit cutter features a quality alloy steel double-ended 10mm diameter cutter, a retractable centre point for quick and easy alignment, and a hexagonal drive shank, 7mm across the flats, for use with most 1/4” variable speed hand drills or larger.